STRUCTURE

• Fiberglass roving & unidirectional reinforcements over foam floors with limber holes
  
• Full length longitudinal floors forming the engine beds, Four (4)
  
• Transverse frames bonded to hull & longitudinal
  

HULL CONSTRUCTION

• Core phased out in way of all thru hulls, struts, shaft logs, rudder ports & center line
  
• Extra reinforcing as required
  
• Rub strakes at water line
  
• Single piece Core Cell cored fiberglass molding
  
• Vinyl ester resin throughout
  
• White CCP gel coat
  

DECK CONSTRUCTION

• Core phased out in way of all through deck fittings
  
• Non skid surface finished in Moon Dust Awlgrip
  
• Overlapping hull/deck joint bonded and fastened every 4"
  
• Single piece Core Cell cored fiberglass molding w/non skid pattern on all working surfaces
  
• White hull, boot top stripe, white deck w/Moon Dust contrasting non skid
  

MECHANICAL

• Aqua Met 1 1/5" propeller shafts with zinc anodes - Two (2)
  
• Bennett trim tabs
  
• Bronze rudders
  
• Bronze stuffing boxes
  
• Dual engine room ventilation
  
• Dual Racor fuel filter
  
• Dual raw water cooled exhausts w/mufflers
  
• Dual raw water intakes with strainers
  
• Engine mounts will be constructed strong enough to handle horse power up to 450 H.P.
  
• Four blade bronze propellers
  
• Fuel tanks, two (2) 160 US gallon vented w/level indicator at helm
  
• Hydraulic steering
  
• Isolated bilge area under engines
  
• Single lever throttle & gear shift controls
  
• Stainless steel steering wheel
  
• Teak slatted platform in engine room
  
• Twin Yanmar 315 H.P. diesel engines w/flexible engine mounts
  
• Yanmar C type engine instrument panels with alarms
  

PLUMBING

• All sea cocks Marelon
  
• Bilge pumps, two (2) 1000 gallon per hour with float switches
  
• Chromed brass faucets, single lever
  
• Holding tank overboard discharge with 12V macerator
  
• Integrated manual bilge pump
  
• Marine manual toilet with 30 US gallon s/s holding tank
  
• Polished Scandvik stainless steel sinks in galley & head
  
• Pressure hot & cold water system for head, shower and galley
  
• Rigid color coded PVC plumbing
  
• Stainless steel water tank, 100 US gallon with level indicator at helm
  
• Water heater, 6 gallon, 110V & engine heat exchanger
  

PROPANE

• All hoses & connectors meet Coast Guard or ABYC requirements
  
• Force 10 stove 2 burner
  
• Propane tank, 10 pound & regulator
  
• Remote solenoid gas shutoff
  

ELECTRICAL

• 110V AC custom distribution panels with meter & polarity indicator
  
• 110V outlets in galley, head, dinette & engine room with ground fault protection
  
• 12V DC custom distribution panel with meters
  
• 12V Norcold refrigerator (IMPROVED DOOR)
  
• All wiring sized & color coded to ABYC specs.
  
• Battery charger, 30amp
  
• Chrome overhead lights in galley, dinette, head & V berth - Four (4)
  
• Chrome swivel reading lights in V berth cabin - Two (2)
  
• Cockpit courtesy lights - Two (2)
  
• Electric horn
  
• Engine gel cell starting batteries - Two (2) in boxes
  
• Engine room lighting
  
• Fire extinguishers in cabin & in cockpit
  
• House gel cell batteries - Two (2) in boxes
  
• Light at Danforth compass
  
• Master battery selection switches, explosion proof Three (3)
  
• Microwave Oven
  
• Running lights & anchor light
  
• Shore power, 110V 30amp with 50' cord
  
• Windshield wipers w/independent on/off switches at helm - Three (3)
  

INTERIOR

• All exposed interior fiberglass in locker interiors covered with teak, cedar or gelcoat
  
• All latches, hinges, catches, & pulls are chromed bronze or brass
  
• All other bulkheads & faces marine grade plywood fiberglassed to hull & deck
  
• Cabin & locker doors solid teak framed
  
• Formica countertops in galley & head with owner's choice of color
  
• Gloss varnished interior teak trim
  
• Gloss varnished teak hi lo dinette table top that converts to double berth
  
• Island berth with 6" foam
  
• Main bulkheads Formica covered marine plywood fiberglassed to hull & deck
  
• Mirror in head
  
• Overhead hatch screens
  
• Removable overhead panels in satin white
  
• Towel rack & toothbrush holder
  
• Upholstered cushions in main cabin with 5" foam
  
• Varnished teak & holly cabin sole
  

DECK

• All deck hardware & fittings 316 stainless steel
  
• Cockpit seat cushions bolstered
  
• Custom chromed inline toe rail chocks - Four(4)
  
• Exterior teak bright work with gloss varnish
  
• Hatches in cockpit sole
  
• Hinged engine & storage access
  
• Large vinyl rub rail with stainless steel half round
  
• Lewmar aluminum anodized hatches - Four(4)
  
• Molded fiberglass settee
  
• Molded helm seat at bridge
  
• Solid teak swim platform
  
• Stainless steel ¼” bow rail extending aft to cockpit
  
• Stainless steel 10" mooring cleats - Six (6)
  
• Stainless steel opening ports - Six (6)
  
• Teak bow sprit with anchor roller
  
• Teak cabin nosing
  
• Teak cockpit coaming
  
• Teak dash
  
• Teak handrails - Two (2)
  
• Teak handrails on cabin top - Two (2)
  
• Teak toe rail 2½" extending aft to cockpit
  
• Upholstered cockpit cushions with 3" foam
  

International Marine Management Inc.

901 Fairview Avenue N Suite #C-150 Seattle, WA 98109, USA

Toll-free 877-213-1463 Tel (206) 282-4262 Fax (206) 464-4262 Email Us

http://immservice.com

---